Runningfish Brass feeler, plug gauge, high-precision clearance gauge, thickness gauge, non-magnetic copper feeler, single piece set, 0.03-1.0mm(100 * 13)

Use the feeler tokeep your hands clean and dry and do not wear gloves.

 Wipe the dust andgrease on the feeler to avoid affecting the measurement accuracy.

 The feeler shouldnot be forced into the measuring gap during measurement, so as to prevent thefeeler from bending or breaking.

 The feeler ruler isrelatively thin and sharp to prevent scratches on the hand or other body parts.

 Can not be used tomeasure the higher temperature of the workpiece.

 After use, thefeeler should be wiped clean and coated with a thin layer of industriallubricating oil, and then the feeler should be folded back into the clampingframe to prevent corrosion, bending, deformation and damage.

 For the measurementand adjustment of the gap, the feeler ruler conforming to the gap requirementsshould be firstly selected to insert into the measured gap, and then the feelerruler should be pulled while adjusting until the locking nut is tightened whenslight resistance is felt. At this time, the value marked by the feeler ruleris the measured gap value.

When storing, do not put the feeler under