Midwest Hearth Remote Receiver Cover Heat Shield for Gas Logs

Midwest Hearth Remote Receiver Cover Heat Shield for Gas Logs and Fireplaces
- All metal construction lined with insulation
- Cut-outs provided on back and side for routing wiring
- Provides additional protection against heat
- Inside dimensions measure 2.5"w x 1-3/8"h x 2.25"d
- Heat shield only, receiver not included
Insulated Metal Remote Receiver Cover

Inside dimensions measure 2.5"w x 1-3/8"h x 2.25"d

The MHRRCM is a protective cover for your remote receiver. The cover is not only attractive, but it also protects the electronics of the receiver from heat generated by your gas fireplace.

Installation Instructions:

Place the MHRRCM onto the remote control receiver. Make sure you have followed the recommended location of the receiver according to the manufacturer's/homeowner's manual. Failure to do so may cause overheating of your receiver and/or reduce the battery life due to the potential for a higher operating temperature. Make sure the insulation is in place and surrounds the remote receiver.
Note: Make sure that you do NOT route the reciver wiring near the burner, flame, or other high temperature surface.

*The MHRRCM does not make your receiver heat-proof. If provides additional protection, but you must still properly locate your remote receiver according to your appliance's instructions.
Country USA
Brand Midwest Hearth
Manufacturer Midwest Hearth
Binding Automotive
ItemPartNumber MHRRCM
Model MHRRCM
Color Black
UPCs 638170653032
EANs 0638170653032
ReleaseDate 0000-00-00

Country	USA
Brand	Midwest Hearth
Manufacturer	Midwest Hearth
Binding	Automotive
ItemPartNumber	MHRRCM
Model	MHRRCM
Color	Black
UPCs	638170653032
EANs	0638170653032
ReleaseDate	0000-00-00

Midwest Hearth Remote Receiver Cover Heat Shield for Gas Logs and Fireplaces

You might also like...