APDTY 028672 Transfer Case Housing Kit (NP8) Rear w/Tail Shaft

APDTY 028672 Transfer Case Housing Kit (NP8) Rear w/Tail Shaft Output Seal
- Brand New Transfer Case Housing (Rear Housing)
- Improved Design Eliminates Pump Rub; Includes Case Housing; Bearing; Bushing; Rubber Plug; Steel Drain Plug with Seal; Large Clip; Small Clip; Seal
- Commonly Needed To Replace A Cracked or Leaking Rear Housing
- Includes Rear Output Tail Shaft Seal; See Compatibility Chart To Verify Your Specific Vehicle Year, Make, & Mod
- Replaces 12473226, 12474949
Brand New Transfer Case Rear Housing Kit
Check Compatibility Chart To Ensure Proper Fit
This Kit Includes A Redesigned Housing That Will Prevent The Common Pump Rub That Causes The Housing To Crack And Leak Fluid. This Is A Very Common Problem Because Gm Transfer Cases Use A Gear To Pump Oil To The Planetary Gears. The Oil Pump Must Float In The Transfer Case Housing And Eventually Rubs. Gm Installed A Sprung Steel Clip In The Housing To Prevent This Wear, However The Clip Breaks Or Wears Out Over Time. The Pump Housing Is Aluminum And Is A Harder Material Than The Oe Magnesium Rear Housing, It Can Wear A Hole In The Rear Housing And Cause A Very Small Fluid Leak. This Leak Is High Up On The Case And Usually Will Not Leak When The Vehicle Is Park And Therefore Does Not How Any Drops On The Ground. This Slow Leak Can Lead To Expensive Internal Repairs Of The Transfer Case.
Replaces 12474949, 12473226
Country USA
Brand APDTY
Manufacturer APDTY
Binding Automotive
ItemPartNumber 028672
Model 28672
UnitCount 1
UPCs 401000084470
EANs 0401000084470
ReleaseDate 0000-00-00

Country	USA
Brand	APDTY
Manufacturer	APDTY
Binding	Automotive
ItemPartNumber	028672
Model	28672
UnitCount	1
UPCs	401000084470
EANs	0401000084470
ReleaseDate	0000-00-00

APDTY 028672 Transfer Case Housing Kit (NP8) Rear w/Tail Shaft Output Seal

You might also like...