BN-180 GPS Module UART TTL Dual Glonass GPS Car Navigation

BN-180 GPS Module UART TTL Dual Glonass GPS Car Navigation with GPS Antenna for Arduino Raspberry Pi Pixhawk Aircraft CC3D F3 Flight Controller Geekstory
- This BN-180 GPS Module can show your speed. When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd.
- The TX LED flash means gps module output normally. The PPS LED flash means gps module locate your place.
- Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable.
- This BN-180 GPS Module does not have FLASH and cannot be saved. 72 Searching Channel Support Rate : 4800bps to 921600bps, Default 9600bps.
- What you will get: 1 X BN-180 GPS Module
Description
Dimension :18mm*18mm*6mm
Weight : 4.9g
Connector : 1.00mm spacing between the 4pins patch seat

Specification
Receiving Format :ã€€GPS,GLONASS,Galileo,BeiDou,QZSS and SBAS
Frequency : GPS L1,GLONASS L1,BeiDou B1,SBAS L1,Galileo E1
Channels : 72 Searching Channel

Sensitivity
Tracking : -167dBm
Reacquisition : -160dBm
Cold start : -148dBm
Hot start : -156dBm

Accuracy
Position Horizontal : 2.0 m CEP 2D RMS SBAS Enable (Typical Open Sky)
Velocity : 0.1m/sec 95% (SA off)
Timing : 1us synchronized to GPS time

Acquisition Time
Cold Start : 26s
Warm start : 25s
Hot start : 1s

Data and Update Rate
Support Rate : 4800bps to 921600bps,Default 9600bps
Data Level : TTL or RS-232,Default TTL level
Data Protocol : NMEA-0183 or UBX, Default NMEA-0183
Single GNSS : 1Hz-18Hz
Concurrent GNSS : 1Hz-10Hz,Default 1Hz

Operational Limits
Altitude : 50,000m Max
Velocity : 515m/s Max
Acceleration : Less than 4g

Power consumption
VCC : DC Voltage 3.0V-5.5V,Typical: 5.0V
Current : Capture 50mA/5.0V
Operating temp :ã€€-40 Â°C ~ +85Â°C
Storage Temp : -40Â°C ~ +105Â°C

Indicator :
TX LED:blue.The data output, TX LED flashing
PPS LED:red.PPS LED not bright when GPS not fixed,flashing when fixed

Wiring:
GND,TX output,RX input,VCC(3.0v-5.5v)

Package Included
1 x BN-180 GPS Module
2 x 15cm Cable
Country USA
Brand Geekstory
Manufacturer Geekstory
Binding Sports
ItemPartNumber 4336324809
Model FZ2917
Color Blue
Size BN-180
UPCs 702795764029
EANs 0702795764029
ReleaseDate 0000-00-00

Country	USA
Brand	Geekstory
Manufacturer	Geekstory
Binding	Sports
ItemPartNumber	4336324809
Model	FZ2917
Color	Blue
Size	BN-180
UPCs	702795764029
EANs	0702795764029
ReleaseDate	0000-00-00

BN-180 GPS Module UART TTL Dual Glonass GPS Car Navigation with GPS Antenna for Arduino Raspberry Pi Pixhawk Aircraft CC3D F3 Flight Controller Geekstory

You might also like...