FLIPSKY HGLTECH BLDC Belt Motor 6354 190KV 2450W for DIY Skate

FLIPSKY HGLTECH BLDC Belt Motor 6354 190KV 2450W for DIY Skate Electric (with The Hall Sensor)
- 【High efficiency】Setup was quick, 7Nm High Torque, Solid torque output and braking, use with ESC which works perfectly. With the Hall sensor, it is the first choice for stable operation.
- 【Strong power】This Esk8 motors test has passed more than 200+ miles, rotating from stationary to ~ 30 rpm.
- 【Wheel customizability】Can be used in DIY Electric Skateboard Electric Bike 、Surfboard ,ect.
- 【Powerful system】The Max Output Watt is 2450W, Max Current: 65 Amps,Max Volts: 12S .Recommend ESC is 3-12S 50A (eFSESC4.12 50A or FSESC 6.6 60A)
- 【Decend design】Good finishing on the whole outer body to Enable Motors Dustproof , with sturdy shaft & Lamination Japan steel startor, used 12awg high strand silicone wire with 4.0mm gold bullet connectors.
Product Spec
Max Power: 2450 Watts
Max Current: 65 Amps
Max Volts: 12S
Max Torque: 7Nm
Motor Resistance: 0.053Ohm
Recommend ESC: 3-12S 50A (FSESC4.12 50A or FSESC 6.6 60A)
Weight: 1.23 lb / 0.56 kg
The motor length:54mm
The motor diameter: 63mm
Shaft: Diameter 8mm, 24mm length, 3x3x15mm keyway slot.
Motor Wire: 130mm silicone 12AWG wire with 4.0mm Gold Bullet Connector Male.
Wire configuration:

Blue = A
Black = B
Yellow = C
BLDC Motor
The number of pole: 14
Sensor Wire: Standard RC Sensor Wire JST-ZH 6pin 1.5mm pitch

Internal PCB with 120 Degree Hall Effect Sensors.
Motor can be used with or without a sensor. Sensorless operation is most common.
ESC Sensor Wires required to use with ESC.
Wire configuration:
Red = 5v
Blue = A
Yellow = C
Green = B
Black = GND

What's Our Product Feature?
Stator: Lamination Japan steel
12awg high strand silicone wire with 4.0mm gold bullet connectors.
Both support sensor and sensorless mode!

Shipping

1X6354 190KV EPOWER Motor (Fits 63mm Motor Mount)
Two types of bottom ID design. Will ship randomly.

Reference Information

The screws used for the motor are M4 metric bolts. Using our motor mounts, we recommend using M4 Socket Cap bolts.
Screws to mount the motor are not included with the motor.
The key for keyawy is not included with motors for shipping
Country USA
Brand FLIPSKY
Manufacturer HGLTECH
ItemPartNumber FS-M008
UPCs 734391065781
EANs 0734391065781
ReleaseDate 0000-00-00

Country	USA
Brand	FLIPSKY
Manufacturer	HGLTECH
ItemPartNumber	FS-M008
UPCs	734391065781
EANs	0734391065781
ReleaseDate	0000-00-00

FLIPSKY HGLTECH BLDC Belt Motor 6354 190KV 2450W for DIY Skate Electric (with The Hall Sensor)

You might also like...